Verifying And Changing Disk Controller Drivers Status - IBM IntelliStation M Pro 6868-5BU System Integration Manual

7-12

Verifying and Changing Disk Controller Drivers Status

Installing and Verifying Avid System Software
The following subsections explain how to verify the installation of the
disk controller drivers and how to change the status (if needed in the
hardware profile).
Verifying and Changing the ATTO ExpressPCI UL3D Driver
Installation and Status
Use the following procedure to check the status of the ATTO driver
only if the board is in the system:
1. Open the Control Panel and double-click the Devices icon.
2. Use the scroll bar to find the Express driver and click to select it.
3. Check the Status column for a device status of Started. This
indicates that the driver installed and initialized properly.
The driver should be listed as a boot device under the Startup
column.
4. Click the Hardware Profile button.
The Device window opens.
5. Select Original Configuration and click the Disable button.
You should now see Express disabled for the Original
Configuration and enabled for the Avid Configuration.
6. Click OK.
7. Click the Close button.