Table of Contents
Advertisement
6-2
Process Overview
n
n
c
Changing System BIOS and Creating Windows NT Image
Once you know the system is working as shipped, and you have
added the memory, the Avid boards, and the fan kit, you need to make
the proper changes to the BIOS and create a Windows NT image on
the system disk.
You will need to enter the BIOS and perform the following functions:
•
Change the boot sequence.
•
Insert the Avid Setup and Product Recovery CD-ROM into the
CD-ROM drive.
•
Exit and save the system BIOS settings.
By going into the BIOS and saving the information, you are also saving the
changes the system detected when you added memory and the display
controller board.
Once you have exited and saved the BIOS, the system boots from the
Avid Setup and Product Recovery CD-ROM and you must do the
following:
•
Install the Windows NT image on the system disk.
You will need the Avid Setup and Product Recovery CD-ROM for
Avid Xpress to install the Windows NT image on the system disk.
You should disconnect all external drives from the system prior to
continuing with this procedure so you do not lose data. You should
only have the original internal drive connected.
Advertisement
Table of Contents
Troubleshooting
