Usb Configuration; Sata Configuration - Supermicro A2SAN-H User Manual

Super A2SAN-H/-E/-L and X11SAN User's Manual
Mini PCIe
ASPM
Use this feature to set the Active State Power Management (ASPM) level for a PCI-E
device. Select Auto for the system BIOS to automatically set the ASPM level based on
the system configuration. Select Disabled to disable ASPM support. The options are
Disable, L0s, L1, L0sL1, and Auto.
PCIe Speed
Use this feature to select the PCI speed for the device installed in the slot. The options
are Auto, Gen1, and Gen2.
USB Configuration
USB3.0 Support
Select Enable for USB 3.0 support. The options are Enable and Disable.
XHCI Pre-Boot Driver
Select Enabled to enable XHCI (Extensible Host Controller Interface) support on a pre-boot
drive specified by the user. The options are Enable and Disable.
XHCI Hand-Off
This is a work-around solution for operating systems that do not support XHCI (Extensible
Host Controller Interface) hand-off. The XHCI ownership change should be claimed by the
XHCI driver. The settings are Enabled and Disabled.
USB Rear I/O USB3.0
Select Enabled for rear I/O USB 3.0 support. The options are Enabled and Disabled.
USB Mass Storage Driver Support
Select Enabled for USB mass storage device support. The options are Disabled and
Enabled.
SATA Configuration
Chipset SATA
Use this feature to enable or disable the onboard SATA controller supported by the SoC. The
options are Enable and Disable.
SATA Mode Selection
Use this feature to select the mode for the installed SATA drives. The options are AHCI and
RAID.
68