Download Print this page
Tennant M17 Instruction Bulletin
Hide thumbs Also See for M17:

Advertisement

Quick Links

INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9015047
SYNOPSIS:
This kit contains the parts needed to replace the sweeping circuit board on M17 sweeper- scrubbers.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 1 hour)
PREPARATION:
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
1. Disconnect the battery cable from the
machine.
WARNING: Always disconnect battery
cables from machine before working on
electrical components.
IB 9015109 (10- 2016)
PROTECT THE ENVIRONMENT
Please dispose of packaging materials, used machine components
such as batteries and fluids in an environmentally safe way according
to local waste disposal regulations.
Always remember to recycle.
No. 9015109
Machine: M17
Published: 10- 2016
Rev. 00
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the M17 and is the answer not in the manual?

Questions and answers

Summary of Contents for Tennant M17

  • Page 1 NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials. Installation instructions for kit number 9015047 SYNOPSIS: This kit contains the parts needed to replace the sweeping circuit board on M17 sweeper- scrubbers. Please follow step-by-step instructions. SPECIAL TOOLS / CONSIDERATIONS: NONE...
  • Page 2 INSTALLATION: Sweeping electrical box location Remove and set SEMS M8 hex screw and left cover aside FRONT FIG. 1 1. Remove the left cover from the machine to access the sweeping electrical box. Set the cover and the SEMS M8 hex screw aside. (Fig.
  • Page 3 NOTE: To avoid damaging electronic components, static ground strap (3) must be worn at all times when handling / installing new sweep circuit board (1) onto machine. Attach other end of static ground strap to machine chassis. Electrical If necessary, enclosure replacestandoffs with new...
  • Page 4 To prevent damaging the sweep circuit board, Do Not over tighten the M4 pan screws. (Fig. 2) Bill Of Materials For Circuit Board Kit, Swp, Main, Afmkt [M17] - 9015047 Tennant Part No. Ref.