To Remove And Replace The Optional Gpib And Rs-232C Cables - Agilent Technologies 1664A Service Manual

To remove and replace the optional GPIB and RS-232C cables

Using previous procedures, remove the following assemblies:
1
•
Handle
•
Rear Feet
•
Cover
•
Disk Drive
•
Power Supply
•
Rear Panel
Disconnect interface cables from the main circuit board.
2
Remove the two hex standoffs connecting the GPIB cable, then slide the GPIB cable
3
forward and out of the rear panel.
Remove the two hex standoffs connecting the RS-232C cable, then slide the RS-232C
4
cable forward and out of the rear panel.
Reverse this procedure to install the GPIB and RS-232C cables.
5
To remove and replace the optional GPIB and RS-232C cables
Replacing Assemblies
6–13