Maintenance - Ranger R980XR Installation And Operation Manual

Maintenance

Make sure your Tire Changer is maintained on a regular basis.
⚠
WARNING
The Tire Changer uses pneumatic and electrical energy; if your organization has Lockout/Tagout
policies, make sure to implement them before performing maintenance on the Tire Changer.
Regular Maintenance
• Daily: Make sure the unit is clean and dry.
• Weekly: Check all labels to make sure they are in place and legible. Contact BendPak Ranger if
replacement labels are needed.
• Weekly: Check the water level of the Regulator/Filter. If the reservoir is one quarter (25%) or more
filled with water, drain it. Refer to
• Weekly: Check the oil feed rate of the Oiler/Lubricator. It should be 1 to 2 drops per use of a
pneumatic component. If it is above or below this level, you need to adjust it. Refer to
Oil Feed Rate and Adding Oil
• Weekly: Check the amount of pneumatic oil in the Oiler/Lubricator reservoir. If it is under one half
(50%) full, add oil. Refer to
• Monthly: Check the accuracy of the Inflation Gauge using a pressurized tire and a high-quality
pressure gauge. Fix immediately if not working correctly.
• Monthly: Make sure all Anchor Bolts are tightened and secure, if used.
• Monthly: Make sure all components are in good operating condition. If you find a component that
not
is working correctly, take the Tire Changer out of service and refer to
more information.
• Twice a Year: Have a licensed Electrician check the electronic components.
• Yearly: Take the Tire Changer out of service, disconnect the Power Cord from the power source,
and then thoroughly check and clean all components.
⚠
WARNING:
R980 Series of Tire Changers
Disconnect the Tire Changer from power and the incoming air from the Air Source
before performing any Maintenance
make sure the unit cannot be re-energized until Maintenance is over (such as
Lockout/Tagout). Because the unit uses electrical and pneumatic energy, you could
be electrocuted or even killed if the unit is powered back on during Maintenance.
Check the Water Level
for instructions.
Check the Oil Feed Rate and Adding Oil
Do not operate your Tire Changer if you find issues; instead, take the unit out of
service, then contact your dealer, visit rangerproducts.com/support/, or call
(805) 933-9970.
. Take whatever steps are necessary to
for instructions.
51
for instructions.
Troubleshooting
P/N 5900158 — Rev. E1 — Nov. 2019
Check the
for