CardioQuip Modular Cooler-Heater Operator/Service Manual
System Drain
The MCH-1000(i) system drain valve is located on the underside of the unit, and allows the
operator to drain all or part of the water from the system. To open the valve, move the valve lever
down to the vertical position. To close the valve, move the lever to the horizontal position (see
photos below).
!
The MCH-1000(m) system drain connector is located on the rear of the unit, below the main
hose connectors, and operates in the same manner as the blanket hose connectors on the
MCH-1000(i).
Tank Drain
The tank drain valve is located on the front panel of the MCH-1000(i), and allows the operator to
drain water from the cold water tank without draining the entire system. This may be useful e.g.
to make room in the tank for more ice during a procedure. To open the valve, turn the valve lever
so that it is parallel with the valve body. To close the valve, turn the lever to that it is
perpendicular to the valve body (see photos below). A standard garden hose may be attached to
transfer the water to a remote drain.
!
System Drain open
Tank Drain open
!
System Drain closed
!
Tank Drain closed
Page 25