Blanket Hose Connectors - CardioQuip MCH-1000 Operators & Service Manual

Page 24 CardioQuip Modular Cooler-Heater Operator/Service Manual

Blanket Hose Connectors

The smaller connectors on the MCH-1000(i), directly
below the "Main" connections on the rear panel of the
MCH, are for connections to patient warming blankets.
Maximum water flow at the blanket connectors is
approximately 4 liters/min (1.0 gal/min). Approximate water flow when connected to a blanket is
1-2 liters/min. The water at the OUT connector is under pressure when the system pump is on.
To connect a hose, firmly push the hose connector straight onto the panel connector until it
"clicks," as shown below.
(CLICK)
! !
To disconnect a hose, push the dark grey button on top of the panel connector, as shown below.
The connector is spring-loaded and will pop off.
! !