Configuring System Security Settings - Oracle MICROS 6 Series Setup Manual

Configuring System Security Settings

On the Security tab, configure the settings as described in the following table:
Table 9-1
Setting
Secure Boot Configuration
Secure Boot Option
Reset to Default
Change to Customization
Set Supervisor Password
Supervisor Hint String
Min. Password Length
HDD Password Select
Set HDDNumber User Password
Set HDDNumber Master Password
TPM Support
BIOS Security Settings
Configuring System Security Settings
Description of Option
Disabled by default. To enable, set the
Supervisor Password.
Enable or Disable the UEFI secure boot
firmware validation process.
Reset secure boot variables to the factory
default.
Delete the protection key, change the platform
to setup mode, and disable secure boot.
Set or clear the supervisor password.
Enter a hint for the password.
Set a minimum length to enforce for user
passwords.
Select the password structure to apply to hard
disk drives:
• User Only: Supports user account
passwords.
• User + Master: Supports user account
passwords and a master password.
Set a password for the user account for this
HDD.
Set a master password for this HDD.
Enable or Disable Trusted Platform Module
support.
By default, TPM Support is disabled.
Chapter 9
9-2