SolidRF Signal Plus Manual page 8

Step5: Introduce (Route) Cables Into Room Through Window
Attention: Don't kink the cable! Avoid
excessive and extreme bending of the
cable in order to prevent damage and
loss of function.
Step6: Connect the System
1. Connect the outside antenna to
the RG6 cable.
3. Connect the another RG6 cable to
the booster at the "INSIDE" port.
5. Connect the other end of the
coax cable to the panel antenna.
2. Connect the outside antenna to the
"OUTSIDE" port of booster with same
cable.
4. Connect the other end of the coax cable
to splitter at the "INPUT" port, and two
inside antennas' cables connect to the
other side port.
6. Plug in the power adaptor and
connect it to the nearest power
outlet.
8