Power Light - SolidRF Signal Plus Manual

Quick Trouble shooting
Correct functioning:
• Power Light should be solid white( the logo on the panel)
• The lights on the front panel indicate the condition of the booster. Every time the
booster is powered on, all of the lights will be green in color for a while then off. This
means the booster has passed the self check and is in good condition..
Incorrect Functioning: (Please see the Troubleshooting Guide for further details)
• If any of the lights on the front panel are flashing in green then off/continue
flashing/solid green, it means that self oscillation is occurring. You must switch off the
booster and check the outside and inside antennas immediately. Make sure you have
followed the recommended installation process and check each step carefully. Refer to
Self Oscillation section for more details of minimum required separation distance,
antennas installation. If you can not fix the problem please contact the technical
support or the reseller.
SolidRF Technical Support: Support@SolidRF.ca
Trouble Shooting: No Signal Improvement
Step 1. Check power. Ensure the indoor
unit is plugged in and the LED Power Light
is green.

Power Light

Panel State Light
13