JUKI AMS-210EN-7450 Instruction Manual page 46

No.
Thread trimming can be prohibited.
Route of return to origin by return to origin button can be
selected.
Bobbin winding speed can be set.
Motion method of wiper can be selected.
Unit of sewing shape size change can be selected.
Thread tension output time when setting thread tension
can be set.
Bend position of thread clamp is selected.
Thread clamp and thread clamp position selection
Thread breakage detection selection
Number of invalid stitches at the start of sewing of thread
breakage detection
Number of invalid stitches during sewing of thread
breakage detection
Feeding frame control : pedal open/close
Feeding frame control : midway stop time open/close
Pedal SW1 with/without latch
Pedal SW2 with/without latch
Pedal SW3 with/without latch
Pedal SW4 with/without latch
Enlarging/reducing function mode
Jog move function mode
Retainer compensation motion : selection of motion
Selection of needle upper dead point at the time
of origin retrieval/return to origin
Temporary stop : thread trimming operation
Main motor X/Y feed synchronized control : speed/pitch
Intermediate presser with/without control
Intermediate presser lowering timing
Intermediate presser : wiper sweeping position
With/without air pressure detection
Intermediate presser DOWN position setting
With/without needle cooler control
Grease-up error
Language selection
Item
– 18 –
Initial value
1600
20
0
8
3
1
1
3.5
-
Not set