Table of Contents
Advertisement
No.
Feeding frame control : midway stop time open/close
Operation order of feeding frame by pedal operation
when lifting the feeding frame by the temporary stop
command in the pattern data is set.
0 : Solid presser
1 : Solid presser 2-step stroke (Down to bottom with presser switch)
2 : Solid presser 2-step stroke (Down to the bottom + start with start switch)
3 : Solid presser 2-step stroke
(Intermediate / down to bottom / going up with presser SW)
4 to 99 : Solid presser
Pedal SW1 with/without latch
Without
Pedal SW2 with/without latch
Without
Pedal SW3 with/without latch
Without
Pedal SW4 with/without latch
Without
Enlarging/reducing function mode
Prohibited
Jog move function mode
Prohibited
Retainer compensation motion : selection of motion
Without motion
Selection of needle upper dead point at the time of origin
retrieval/return to origin
Without
Temporary stop : thread trimming operation
Automatic thread
trimming
Item
With
With
With
With
Increasing/decreasing
Increasing/decreasing
number of stitches
(Pitch is fi xed.)
Parallel move
2nd origin specifi ed later
With motion
With
Manual (Thread trimming by
turning Stop SW ON again)
– 15 –
Setting range
0 to 99
pitch (Number of
stitches is fi xed.)
Edit unit
1
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
Advertisement
Chapters
Table of Contents
