Inkbird ITC-608T Manual page 8

A
Functions on screen
PV：
In normal mode, the measured temperature is displayed.
In settings mode, it will display menu code.
SV：
In normal mode, the temperature setting value is
displayed. In setting mode, it will display the setting value.
B
Output(WORK1/WORK2) Instruction
WORK1:
The heating output
WORK2:
The cooling output
C
Indicator LED:
●Red LED is on
●Green LED is on
●Green LED is blinking
function of compressor delay.
●Yellow LED is on
D
Button Instruction
Please read the detail on 2.Button Operation Instructions below.
E
Probe interface
Temperature probe can be insert into P1 or P2 interface.
F
Temperature probe
If the controller display Er, you may get a false temperature
probe, please try harder to insert the probe and rotate it to
make good contact. If the problem is still persists, it is likely the
internal probe wire has been damaged by the moisture or heat
temperature.
The probe and cable cannot be touched by the flame.
Do not exceed the probe temperature range to avoid
damaging.
WORK1 output is on.
WORK2 output is on.
WORK2 output is performing the
The controller is in the setting mode.
6