Setting Humidity Control Function - Inkbird ITC-608T Manual

3.2 Setting Menu Instruction
Code Symbol
HS
HS
HD
DD
AH
AH
AL
PT
CA
CA
4.Control Function Instruction
4.1 Setting Humidity Control Function ( HS ,HD, DD )
When the controller works normally, PV shows the measured
humidity, meantime SV shows the humidity setting value, and
automatically recognizes and converts for the humidification
and dehumidification working mode .WORK1 is the humidifica-
tion output, furthermore the red led is the WORK1 humidifica-
tion output status indicator; WORK2 is dehumidification
output, furthermore the green led is WORK2 dehumidification
output status indicator.
When PV(measured humidity) ≤ HS(humidity setting value) –
HD(humidification difference value), the controller will enter
into the humidification state, the red led is on, WORK1 output
works. When PV(measured humidity) ≥ HS(humidity setting
value), the red led is off and the WORK1 output turns off.
When PV(measured humidity) ≥ HS(humidity setting value) +
DD(dehumidification difference value), the controller will enter
into the dehumidification state, the green led is on, WORK2
output works; green led flashes, indicating that the dehumidi-
fication device is in delay protection state. When PV(measured
humidity) ≤HS( humidity setting value), the green led is off and
the WORK2 output turns off.
For example, when setting HS=50.0%RH，DD=5.0%RH，
HD=8.0%RH, measured humidity value ≥55.0%RH(HS+DD),the
controller will enter the dehumidification state, when
measured humidity value ≤50.0%RH, dehumidification will
Function
Humidity Setting
Value
Humidification
Difference Value
Dehumidification
Difference Value
Alarm High Humidity
Limit
Alarm Low Humidity
Limit
Compressor Delay
Time
Humidity Calibration
41
Setting Range
5.0%RH ~99.0%RH
1.0%RH ~20.0%RH
1.0%RH ~20.0%RH
5.0%RH ~99.0%RH
5.0%RH ~99.0%RH
0~10 minutes
-20.0%RH ~20.0%RH
Default
Setting
50.0%RH
5.0%RH
5.0%RH
99.0%RH
5.0%RH
0 minute
0.0%RH