Start The Engine Electrical- Ly - Bomag BPR 35/42 D Operating Instructions, Maintenance Instructions

4.5 Start the engine electrical-
*
ly .
Fig. 16
Set the throttle lever (Fig. 16) to position "MIN"
l
(idle speed).
Danger
!
Danger of injury!
Before starting make sure that there are no
persons in the danger area of engine or ma-
chine and that all safety installations are in
place.
Do not use starting aid sprays or other inflam-
mable fluids for starting.
Fig. 17
Turn the ignition key to position "I" (Fig. 17),
l
the warning buzzer sounds.
* Optional equipment
BPR 35/40 D BPR 35/60 D
Fig. 18
Then turn the ignition key further to position "II"
l
(Fig. 18), the engine will start.
As soon as the engine runs, guide the ignition
l
key back to position I.
The warning buzzer stops.
Fig. 19
Run the engine warm for a short while before
l
starting work (Fig. 19).
Operation of the vibratory plate can be started
l
once the engine has warmed up for a while.
Caution
!
When the engine is running leave the ignition
key in position I.
If the starting attempt takes longer than 10 sec-
onds wait at least 15 seconds before trying
again.
Excessive running of the starter will discharge
the battery.
B O M A G
O p e r a t i o n
2 5