SunStar SJS/A-BA2 User Manual page 27

① Press READY and basic patterns are displayed.
① Use UP/DOWN keys to select among patt, X_len,
Y_hei, Zigz, X-bar, Bar, move and x-pit, and set a
value pressing +/- keys.
② Press ENTER to create a pattern.
Stay stitch type
① If a value entered is beyond the range, ERR22 appears
on the screen.
ERR53 : Length (X_len),
ERR55 : Pitch (pit),
② Press ESC and enter a new value again.
28
• patt : Pattern number
•X_len(length) : Basic (6~22 mm) / Extended (6~30 mm)
•Y_hei(height) : 1~3.2 mm
•Zigz(No. of zigzag) : 6~35
•X_bar : Number of stitches in the straight line at the beginning (2~10)
•BAR : Zigzag for all straight lines
- Bar(Start from Origin #2), Ori(Start from Origin)
- One(No. 1 at the left end from the center), No(no Bar)
•move : Offset function (-2~2mm)
•x_pit : Length of pitch (automatic calculation)
Start point
Bar Ori
ERR54 : Height (Y_hei)
ERR56 : bar
Start Point
Start Point
No
↓
↓
Start Point
Mid
JUMP