Troubleshooting - SunStar SJS/A-BA2 User Manual

■ Troubleshooting

No Error Message
1 ERR6
2 ERR16
3 ERR36
4 ERR8
5 ERR13
6 ERR18
7 ERR21
8 ERR30
9 ERR31
10 ERR32
11 ERR33
12 ERR34
13 ERR35
14 ERR41
15 ERR42
16 ERR43
17 ERR44
18 ERR45
19 ERR46
20 ERR47
21 ERR48
22 ERR49
23 ERR129
Check the X cable and sensor. Check the XY step board.
Check the Y-cable and sensor. Check the XY step board.
Check if a cable is separated or check the XY origin sensor.
Check if extended ROM is equipped and conduct initialization.
Conduct formatting (Press PF, ESC, and Power-On at the same time)
Sewing data transmission value error. Regenerate patterns.
Check if the supply device enters into the sewing machine within two seconds.
Check the S5 wiring sensor that detects sewing fabric seams (mechanical part
resetting).
- The error occurs when the belt fabric connection part is detected three times in
a row.
Initialize OP Box parameters and check OP Box's 24LC08.
① Check if AT28C010 is installed at the OP Box.
② Conduct initialization (Press PF, ESC, and Power-On at the same time).
※ Generate patterns after initialization.
① Check the air pressure.
② Check the pneumatic sensor on the rear side of the sewing machine.
③ Press (-) key and change Para No. 9 value.
④ Parameter change: Press (-) key and set Parameter No. 9 Air at off.
Check if input voltage is unstable or power is turned off.
Check if the pneumatic cable is separated or not properly attached to the rear side
of the OB Box
Check if the supply device's return is detected by the sensor (S1).
Check if the clamp's advance is detected by the sensor (S8).
Check if the clamp's return is detected by the sensor (S2).
Check if the supply device's advance to the middle is detected by the sensor (S7).
Check if the cutting part's advance (S4) is detected by the sensor.
Check if the clamp pulling is detected by the sensor (S7).
Check if the clamp's fabric seam is detected by the sensor (S5).
Check if the supply device's advance is detected by the sensor (S3).
Check the sensor below the hook (S1).
Check if any load on the motor is found.
- Turn the pulley and check any load
Corrective Action Remarks
45