4.8.2) Step Move (operation by step)
① Press Up/Down keys to select Step or Continue.
② Press ENTER, and the machine is in motion.
(Step: step-by-step motion, Continue: continuous
motion)
③ When Step is selected, each step motion begins
whenever pressing ENTER.
■ When each step motion is selected and ENTER is pressed, the following motions take place by step.
Step
Description
1
Clamp moves forward
5
Clamp moves back to
the middle
9
Clamp pressure
increases
13
Supply device moves
forward
17
Supply device moves
back
① Select Continue and press ENTER. Then continuous
motion is set.
② Press ESC to return to the previous screen.
4.8.3) Solenoid Test
① Use Up/Down keys to select an item. When ENTER is
pressed, the solenoid operates.
(On: Operate / OFF: Return)
Step
Description
2
Pin spins
6
Supply device moves to
the middle
10
Cutter ascends
14
Supply device descends
18
Presser foot ascends
Step
Description
3
Fabric is held
7
Middle part pressing
increases
11
Clamp fully moves back
15
Middle part pressing
decreases
↓
Step
Description
4
Clamp moves to the
middle
8
Cutter descends
12
Pin spins
16
Presser foot descends.
↓
↓
37