Mounting Instruction - R82 High-low:x Mounting Instruction

Mounting instruction

Mounting foot pedals on High-low:x frames
Remove the gas spring:
* Remove the bolt (A) and loosen the lock nut (B).
* Unscrew the gas spring.
Remove the old fitting:
* Remove the bolts (C) and the pedal-fitting (D).
Mount the new pedal:
* Mount the new fitting (E) loosely with the enclosed screws (F).
Make sure that the screws (F) are mounted into the same holes
(K) as with the old fitting.
* Place the pedal i the fitting as shown on the drawing (G).
* WHen the pedal points in the right direcion, you fit the small
'banana'-plates (H) med 5 mm screws.
* The spring (I) is placed in the small hole by the joint of the under-
neath of frame.
Mount the gas spring:
* Screw the gas spring back into the release house. Make sure that
the pin hits the curved part (J).
* Tighten the lock nute (B) and the bolt (A).
* Tighten the new bolts (F).
Make sure that the frame can be adjusted up and down. Adjust
the gas spring if necessary, as described in the manual for the
x:panda.
A
B
C
D
F
E
J
G
H
K
I