Table of Contents
Advertisement
Document No. 125-1009
Installation Instructions
February 10, 2020
Siemens Part
Number
QAA2330.EWNN
QFA33SS.EWNN
QAM2030.010
QFM2160U
QPA2000
QPA2062
QPM2162
QAC2030
QAD2030
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and the receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Modifications
This device complies with Part 15 of the FCC rules and IC rules. Changes or modifications not expressly approved by Siemens Industry Inc. could void
the user's authority to operate the equipment.
Industry Canada
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
CAN ICES-3 (B)/NMB-3 (B)
Limited Warranty
Siemens Product Guard Warranty warrants the purchased from it or its authorized reseller to be free from defects in material and workmanship under
normal use during the two-year period commencing on the date of purchase. The written proof of purchase is required for such warranty period to apply.
The software included in this Siemens product is licensed for use subject to the Siemens end-user license agreement ("EULA") posted at
www.usa.siemens.com/btcpseula (Siemens' EULA web site) for this software identified by product model or part number on the Siemens EULA web site.
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models as
design improvements are introduced. APOGEE is a registered trademark of Siemens Industry, Inc. Other product or company names mentioned herein
may be the trademarks of their respective owners. © 2020 Siemens Industry, Inc.
Siemens Industry, Inc.
Smart Infrastructure
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
USA
+1-847-215-1000
Table 15. Suggested Sensors for Use with RDY2000BN.
Description
Remote Wall-Mounted Sensor – Temperature Only
Remote Wall-Mounted Temperature and Humidity Sensor
Duct-Mounted Temperature Sensor
Duct-Mounted Temperature & Humidity Sensor
Wall-Mounted CO2 Sensor
Wall-Mounted Temperature + Humidity + CO2 Sensor
Duct-Mounted Temperature + Humidity + CO2 Sensor
Outdoor Air Temperature Sensor
Surface-Mount Pipe Temperature Sensor
Your feedback is important to us. If you have
comments about this document, please send them
to
SBT_technical.editor.us.sbt@siemens.com
Signal Format
10K Ohm, Type II NTC
0-10V
10K Ohm, Type II NTC
0-10V
0-10V
0-10V
0-10V
10K Ohm, Type II NTC
10K Ohm, Type II NTC
Document No. 125-1009
Printed in the USA
Page 18 of 20
Hide quick links:
Advertisement
Table of Contents
