Thermo Scientific AutoPILOT PRO User Manual page 66

Thermo Fisher Scientific
5. Refer to Figure 5–3 for the following.
a. Connect a cable from the backplane at J1 to J32 on the back of the
main board. (J32 shown in
b. Connect J8-2 (GND) on the backplane to TB1-4 (NEG) on the
enclosure door panel.
c. Connect J8-1 (VSOURCE) on the backplane to TB1-1 (POS) on
the enclosure door panel.
Figure 5–3. Installing the I/O expansion backplane for the AI expansion
option
6. Return the main board and mounting bracket to the down position,
tighten the thumbscrews, and shut the enclosure door.
Other I/O Expansion Options
Analog Input Expansion Option
Figure C–2.)
AutoPILOT PRO Flow Computer User Guide 5-3