Kohler HYDRO-TOWER 100 K-6281T-NA Installation Instructions Manual
Kohler HYDRO-TOWER 100 K-6281T-NA Installation Instructions Manual

Kohler HYDRO-TOWER 100 K-6281T-NA Installation Instructions Manual

Touchless inwall tank with frame

Advertisement

Read installation guide in illustration and word file
carefully, and install Z Z the tank according to instructions in
the guide to avoid product damage and installation
inconvenience caused by inappropriate operation.
All data contained is based upon the last product
information available at the time of publication. Kohler
Company reserves the right to implement changes of
product characteristics, packaging and availability at any
time without further notice.
Do not apply erosive cleanser and solvent in the tank,
which will damage tank spares and result in leakage in the
tank. Kohler will not be responsible for any damage
related to above mentioned cleanser or solvent.
Do not apply spares that are not provided by Kohler, and
please note that glass adhesive tape shall not be applied
to the installation of Kohler spares. Kohler will not be
responsible for any damage related to installation with
spares not provided by Kohler.
Wall-hung Toilet That Matches The Tank
K-8752T/K-8752T-S ODEON Wall-hung P-Trap Toilet
K-18133T/K-18133T-S PRESQU'ILE Wall-hung P-Trap
Toilet
K-19045T ESCALE Wall-hung P-Trap Toilet
K-18609T VIA Wall-hung P-Trap Toilet
K-17647T/K-17647T-S OVE Wall-hung P-Trap Toilet
K-18132T/K-18132T-S FREELANCE Wall-hung P-Trap
Toilet
Function Explanation
Single/double gear touchless flush
Single/double gear manual flush
Anti flow-backwards
Adjustment of inlet water level
Adjustment of flushing volume
Adjustable toilet height
Advantages Of Touchless In-wall Tank
Not only does the tank is equipped with single/double gear
manual flush function, but also it is able to distinguish and
complete flushing action depending on different ways of excretion.
Anti-strike and erosion proof tank of macromolecule
materials, and leak proof.
Advanced tank spares, adjustable to
Impact free to wall structures, and excellent sound
insulation effect.
Easy installation and time efficient.
Easy maintenance and no necessity of removing the wall
in the process of maintenance.
Clean, Garbage free, and space efficient.
1104563-T01-C
flushing
of 3/6 liters.
上海科勒电子科技有限公司
上海市浦东新区金滇路18号E幢 邮编:201206
海德丽100 HYDRO-TOWER 100
Touchless Inwall Tank with Frame
K-8752T/K-8752T-S奥帝安挂墙式座便器
K-18133T/K-18133T-S佩斯格挂墙式座便器
K-19045T艾思格尔挂墙式座便器
K-18609T维雅挂墙式座便器
K-17647T/K-17647T-S欧芙挂墙式座便器
K-18132T/K-18132T-S费丽兰挂墙式座便器
双档自动感应冲水功能
双档手动冲水功能
防倒流功能
进水水位可调节功能
冲水水量可调节功能
座便器高度可以调节功能
自动感应入墙式隐藏水箱的优点
不仅具有单、双档手动冲水功能,还能自动感应区分大小便,
并完成相应的大、小水量分档冲水。
-1-
自动感应入墙式隐藏水箱
安装说明书
INSTALLATION INSTRUCTIONS
K-6281T-NA
3/6
Copyright Kohler China Ltd., 2010
, 2010

Advertisement

Table of Contents
loading

Summary of Contents for Kohler HYDRO-TOWER 100 K-6281T-NA

  • Page 1 Kohler will not be responsible for any damage related to above mentioned cleanser or solvent. Do not apply spares that are not provided by Kohler, and please note that glass adhesive tape shall not be applied to the installation of Kohler spares. Kohler will not be responsible for any damage related to installation with spares not provided by Kohler.
  • Page 2: Sensor Specifications

    SENSOR SPECIFICATIONS Model K-6281T-NA K-6281T-NA Power 220V AC 50/60Hz 220V AC 50/60Hz Large flushing volume: 6L 大档水量:6L Liter per flushing Small flushing volume: 3L 小档水量:3L Environmental temperature: 1 ~55 : 1 ~55 1 ~45 Temperature Water temperature: 1 ~45 Within 70cm from sensing window Sensing distance 距感应窗口70cm以内(沿发射角度方向)...
  • Page 3: Installation

    INSTALLATION A. 自动感应入墙式隐藏水箱的安装 A. Installation of In-wall Tank Fix the fixing cap into the holes of fixing frame, then 如图A将内六角螺丝连同固定套装在水箱架小孔内。然后将 tighten the hexagonal screws on the fixing frame 螺母紧锁在内六角螺丝上,再用内六角扳手把内六角螺丝拧 with hex pan as shown in Fig. A. 紧在水箱架上。 Tighten the bolts with medium Allen key as shown 如图B用内六角扳手拧松螺母,使可调支架可以按照客户的...
  • Page 4 Put the frame to the desired location, fixation of the 将水箱放置到合适位置,对准固定架上的螺丝孔和地面上 screw holes on the ground and the expansion of the 的两个膨胀螺钉,如图A用内六角扳手把六角长螺丝拧紧。 two Bulge Screw, Tighten the hexagonal long screw 注意要保持水箱架的水平。 with hex pan as shown in Fig. A. Please ensure the frame remains level.
  • Page 5 6. Fix the transformer onto the wall, as illustrated, 6. 将变压器固定在墙上的合适位置,按照如图所示走线, connect the output connector of transformer (brown) 将变压器的低压输出端(棕线)穿过电工套管(建议电工 with the low-voltage AC input connector in tank, and 套管管径φ16~φ20)与水箱内的低压AC输入端相连, put the connector outside the tank. Connect the input 接好后将线头连接处拉至水箱内的顶部,不能沉入水中, connector of transformer (black) with power supply 电工套管如图示固定后,变压器的高压输入端(黑线)...
  • Page 6 如图示,将电机线(含面板连接头和低压电源线连接头) 3) Fix the motor wire (panel connector and low-voltage 固定在右上角的软扎线上。 connector included) to the soft belt on the right upper corner. 注意:不要让线和接头掉在水中。 NOTE: Don’t let the wire and connector fall into water. String 软扎线 Motor Wire 电机线 4) Cover the drainage cap with big filtration cap, and the drainage hole with small filtration cap.
  • Page 7: Installation Of Toilet

    C. Installation of Toilet 1. Install the inlet pipe and outlet pipe to the lavatory as shown, and mark on the pipes at the back side of the tank with a ruler and a pencil, and reserve appropriate space according to the distance from the back of the tank to the outlet hole on the wall.
  • Page 8 4. 48mm-58mm of the long screw shall be reserved outside the wall as shown in the illustration. If the long screw outside the wall is not long enough or much longer than that needed, it should be adjusted with screwdriver or by hand.
  • Page 9 D. Installation of Cover 1. 打开水箱内部进水角阀。 1. Open the inlet corner valve located inside the frame. 如图将调节板装在墙壁上,然后用手旋转锁紧管使调节板固 2. Fix the adjustable board to the wall by tightening the 定。锁紧管需对准“LOCK”标识。(调节板已有标识,安装时 lock nut as shown in the figure. And the locknut should 请按标识进行)。...
  • Page 10 5. As illustrated, make the locker of panel aim at locker of adjusting board, lock them closely as the point. 5. 如图将面板的扣位对准调节板的倒扣,以此为支点向前旋转扣紧。 Cover Cover 面板 面板 Lock 扣位 AdjustableBoard 调节板 Sensing Window 6. In-wall tank toilet is ready to be put into use. 自动感应窗口...
  • Page 11 2. Loosen the long screw as shown. Long Screw 3. Tighten the locknut to the marked position of OPEN take out the adjustable board. OPEN Adjustable Board Locknut 4. Take out the adjustable board as shown. Adjustable Board 1104563-T01-C -11-...
  • Page 12 5. 将电机线从软扎线上取下,用螺丝刀松开两个锁电机盒 5. Take motor wire out of the soft belt, release the two screws 的螺丝。 that locked the box. 注意:螺丝不会轻易退出,只要感觉螺丝拧出螺纹即可。 NOTE: Screws will not quit easily, just feeling that the screw is threaded out is enough. String 软扎线 Screw 螺丝...
  • Page 13 8. Remove the lock and reversed lock as illustrated. 8. 如图把杠杆扣与倒扣拆出。 Reversed Lock 倒扣 Pole Lock 杠杆扣 9. Take out the inlet valve as shown. Loosen the terminal of the pipe, then grasp the top of the inlet valve and push back.
  • Page 14 11. Move the lock on or off by hand. Note: Move the lock on and open the cover, then the outlet valve can be loosen. Open Close 开 关 Lock 卡扣 Cover 压盖 12. Turn the outlet valve in according to the arrow direction, then the outlet valve can be taken out.
  • Page 15 . Adjust Drainage Valve As illustrated, flush valve could be used to adjust the flushing volume of the tank ,1.Adjustment of the big volume: Regulate the opening and closing holes, as illustrated, the larger the hole, the smaller the flushing volume and vice versa. 2.Adjustment of the low volume: The higher the float, the less the flushing volume and vice versa.
  • Page 16: Troubleshooting Procedures

    TROUBLE SHOOTING PROCEDURES TROUBLE SHOOTING PROCEDURES Symptoms Probable Causes Recommended Action 1. The inlet valve is closed 1. Open inlet valve(refer to page 14) No water fills in via inlet Floating box of inlet valve is blocked by tank wall Adjust floating box to appropriate position valve 3.Floating box of inlet valve is block by waste...
  • Page 17 海德丽100 HYDRO-TOWER 100 自动感应入墙式隐藏水箱 Touchless Inwall Tank with Frame 安装说明书 INSTALLATION INSTRUCTIONS K-6281T-NA 1110039 1110042 G12Filter/G12过滤器 Filter Joint 1110963 过滤器接头 Fixation Shank G06Valve/G06角阀 锁紧管 TankInletConnection 水箱进水头 Washer/ 垫片 LocationPanel Nut / 螺母 定位板 1110040 1110962 Push Bar Pipe 推杆 编织管 Joint Nut ST3.5 Screw 连接螺母...
  • Page 18 海德丽100 HYDRO-TOWER 100 自动感应入墙式隐藏水箱 Touchless Inwall Tank with Frame 安装说明书 INSTALLATION INSTRUCTIONS K-6281T-NA 1101486 1110969 Motor Box Assy. Rubber Stopper Gasket 电机控制盒组件 密封圈(含配件说明) 1098699 Swing pole is placed to reset position Lens 摆杆复位状态 透镜 1108553 1110967 Screw/螺丝 Screw/ 侧缸螺丝 Screw Cover/ 螺丝底盖 Screw Washer/ 螺丝垫...
  • Page 19 海德丽100 HYDRO-TOWER 100 自动感应入墙式隐藏水箱 Touchless Inwall Tank with Frame 安装说明书 INSTALLATION INSTRUCTIONS K-6281T-NA KL-F KL-C M10 Interior Hexagon Wrech M10的内六角螺丝刀 M5 Interior Hexagon Wrech M5的内六角螺丝刀 Tank Bracket Assy. 水箱支架组件 KL-G Inwall Tank KL-D 隐藏式水箱 Nut 螺母 Spring Gasket 弹性垫片 Gasket 垫片 Bulge Screw 膨胀螺钉...
  • Page 20 -20- 1104563-T01-C...

Table of Contents