Kohler HYDRO-TOWER 100 K-6281T-NA Installation Instructions Manual page 5

6. Fix the transformer onto the wall, as illustrated,
connect the output connector of transformer (brown)
with the low-voltage AC input connector in tank, and
put the connector outside the tank. Connect the input
connector of transformer (black) with power supply
220V AC. Customer can use the PVC pipe for wiring.
WARNING: Don't mistake the input connector and output
connector, or product may be damaged.
low-voltage AC
变压器低压输出端
Low-voltage AC input
connector in tank
低压AC电源连接线
(水箱内)
B. Installation of Rectangular Shield
1) Cut the cover with a knife as shown.
WARNING: Do not allow the knife enter the box deeper
than 15mm, otherwise it may damage the
electric wire inside.
2) Install the rectangular shield in the block screen of the tank,
and tighten the screw to fix the rectangular shield to the
tank.
2)
1104563-T01-C
ceiling
天花板
-5-
6. 将变压器固定在墙上的合适位置，按照如图所示走线，
将变压器的低压输出端（棕线）穿过电工套管（建议电工
套管管径φ16～φ20）与水箱内的低压AC输入端相连，
接好后将线头连接处拉至水箱内的顶部，不能沉入水中，
电工套管如图示固定后，变压器的高压输入端（黑线）
接AC220V交流电。
警告：请勿接错变压器的输入输出接线端，否则可能损
坏产品。
Connect AC 220V
接AC 220V
Brushing Pipe
电工套管
Output AC 6V
输出AC 6V
B. 方形罩的安装方法
1)
如图用美工刀剪开保护面板。
警告：美工刀伸入箱体内的长度不能超过15mm,否则可能
Knife
美工刀
螺丝
Input AC 220V
输入AC 220V
Transformer Assy.
变压器组件
Cover
保护面板
Block Screen
挡盖
Rectangular Shield
方型罩
Screw