Kohler HYDRO-TOWER 100 K-6281T-NA Installation Instructions Manual page 6

3) Fix the motor wire (panel connector and low-voltage
connector included) to the soft belt on the right upper
corner.
NOTE: Don't let the wire and connector fall into water.
4) Cover the drainage cap with big filtration cap, and the
drainage hole with small filtration cap.
4)
5) Tighten the long screw into the holes of tank bracket.
5)
6) When finishing the brickwork of the wall, take out the big
and small filtration caps, and eliminate unwanted
rectangular shield with a sharp knife.
NOTE: Build by laying bricks or stones, ensure the screw
could rotate freely.
6)
超出墙面的
注意：砌墙时，需保证螺杆能自由转动。
美工刀
割
如图示，将电机线（含面板连接头和低压电源线连接头）
3)
固定在右上角的软扎线上。
注意：不要让线和接头掉在水中。
Big Filtration cap
大防物盖
Big Filtration Cap
大防物盖
-6-
String
软扎线
Motor Wire
电机线
Small Filtration cap
小防物盖
Long Screw
长螺杆
Rectangular Shield
方形罩
Small Filtration Cap
小防物盖
1104563-T01-C