Kohler HYDRO-TOWER 100 K-6281T-NA Installation Instructions Manual page 15

B . Adjust Drainage Valve
As illustrated, flush valve could be used to adjust the flushing
volume of the tank ,1.Adjustment of the big volume: Regulate the
opening and closing holes, as illustrated, the larger the hole, the
smaller the flushing volume and vice versa. 2.Adjustment of the low
volume: The higher the float, the less the flushing volume and vice
versa.
B.
如图排水阀可调节水箱排水量的大小：（1）大档冲水量调节方法：
调节小孔的开合程度，如图示，向下调节水量越大，反之越小。
（2）小档冲水量调节方法：浮筒越高，冲水量越小，反之越大。
C. Adjust Inlet Valve
Hoist and reduce the water level in the tank by adjusting
the control pole. Turn the control pole counterclockwise to
lower down the floating box and reduce the water level of
the tank. Turn the control pole clockwise to hoist the
floating box and increase the water level in the tank.
C.
D. Clean the sensing window
Keep the sensing window clean. Wipe with soft cloth and mild cleaner.
Note:
a. Do not use dust-removing powder, abrasive powder or
cleaner containing oil, acid or alkaline ingredient.
b. Do not spray air-refresher, disinfector, or other deodorizing,
cleaning solvent directly into the sensing window.
c. Keep wire away from water.
d. Don't attack the sensor window.
D. 清洁感应窗口
保持感应窗口清洁，可用蘸有中性清洁剂的软布擦洗。
注意：
a. 禁止使用去污粉、研磨粉及油类、酸性类、碱性类清洁剂。
b. 禁止直接对感应窗口喷洒空气清新剂、消毒液或其他除臭、
清洁类有机溶剂。
c. 避免水直接接触电线接插件。
d. 勿撞击感应窗口。
1104563-T01-C
Adjustment Switch
Inlet Valve
Long Flush
Button
-15-
Floating Box
Drainage valve
Control Pole
Floating Box
Sensing Window
感应窗口
Short Flush
Button