Related Manuals for Clarke CD1970
Summary of Contents for Clarke CD1970
- Page 1 DEHUMIDIFIER DEHUMIDIFIER MODEL NO: CD1970 Part No: 6470627 USER INSTRUCTIONS 0306...
-
Page 2: Table Of Contents
Waste electrical products should not be disposed of with household waste. Please dispose of at your local recycling facility. Please Note that details and specifications herein, are correct of time of going to print. However CLARKE International reserve the right to change specifications at any time without prior notice. Copyright CLARKE International All rights Reserved 03/2006. -
Page 3: Safety Precautions
SAFETY PRECAUTIONS WARNING: PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING This appliance is intended for domestic and light office use ONLY. Any other use is not recommended by the manufacturer and may cause fire, electric shocks or other injury to person or property. •... -
Page 4: Electrical Connections
SAFETY PRECAUTIONS CONTINUED • DO NOT use the unit without the AIR FILTER. • Check the household voltage to ensure it matches the units rated specification before operating. ELECTRICAL CONNECTIONS This product is provided with a standard 13 amp, 230 volt (50Hz) BS1363 plug, for connection to a standard, domestic electrical supply. -
Page 5: Technical Specification
TECHNICAL SPECIFICATION Description: Model No: .................... CD1970 Part No: ....................6470627 Use: ................Domestic/small office Product Specification: Operating Voltage: .................. 230V Motor Wattage: ..................420W Operating Temperature: ..............2°C - 39°C Max Extraction Rate: ..............20 Litres/Day Tank Capacity: ................... 4.6 Litres Dimensions &... -
Page 6: Parts Description
PARTS DESCRIPTION FRONT VIEW Handle Air Outlet Control Panel Sensor Water Tank (DO NOT block) Float Window REAR VIEW Air Inlet (DO NOT block) Continuous Water Power Cable Drainage Outlet & Mains Plug Rear Wheels... - Page 7 PARTS DESCRIPTION CONTINUED CONTROL PANEL ON/OFF Button. In stand-by mode, pressing the ON/OFF button will start the unit and pressing the button again will switch it off. MODE Button. When the mode button is pressed the unit will cycle though the operational modes: - Dehumidify - Laundry - Quiet.
-
Page 8: Setup & Operation
SETUP AND OPERATION OPERATIONAL PROCEDURES Before Operating If the unit has been stored/moved laying down, leave it to stand in an upright position for two hours before operating. Connect The Power Insert the mains plug into the power socket and switch the socket ON. When power is properly connected the power indicator light on the control panel will illuminate. - Page 9 SETUP AND OPERATION CONTINUED WATER TANK EMPTYING If the water tank is full (approx. 4.6 litres), the indicator light on the control panel will be lit and the unit will automatically stop operating. Switch the unit OFF on the control panel and then switch it OFF at the wall socket.
- Page 10 SETUP AND OPERATION CONTINUED To reinstall the water tank push it back to its original position. NOTE: the unit will not function if the tank is incorrectly installed. DO NOT Remove the float or sensor in the water tank, they are used to monitor the water level.
- Page 11 SETUP AND OPERATION CONTINUED Insert the drain hose into the water outlet opening. Pass the water hose though the outlet opening and firmly push it into the water outlet of the main unit. DO NOT block the hose. Place the water tank back in its original position. Make regular checks when the hose is first installed to ensure that it is properly connected and there is no blockage.
-
Page 12: Maintenance
MAINTENANCE ALWAYS Turn the unit OFF and disconnect from the power supply before proceeding with any cleaning or servicing. To clean the unit use a soft cloth to wipe off any dust. If the unit is very dirty use a damp cloth and wipe dry. DO NOT use any cleaning detergents , sprays or other chemicals as they will damage the unit. -
Page 13: Trouble Shooting
TROUBLE SHOOTING PROBLEM: The unit does not turn ON. CAUSE: TROUBLE SHOOTING: Is the power cable disconnected? Plug in the power cable correctly. Empty the water tank and ensure that Is the full indication light ON? it is correctly installed. (the water tank is full, or the water tank is not correctly installed). -
Page 14: Parts List
PART NO: Air Filter ................EH197001 Active Carbon Filter ............EH197002 WARNING: The use of spare parts or accessories, other than those supplied by CLARKE international or one of its recognised dealers, may be hazardous and could invalidate the guarantee.