WAGNER WallPerfect I-Spray 1800 Manual page 14

GB
Assembly
The I-Spray nozzle, air cap and needle are optimally adjusted to suit each
i
other. Do not combine components with different spray attachments, as the
components could be damaged.
CAUTION! The units may only be used with a functional valve. If paints
rises in the ventilating hose (Fig. 1 A, item 15) do not operate the unit
further! Dismantle and clean the ventilating hose, valve and diaphragm
and replace the diaphragm if necessary.
Spritzpistole nicht legen!
1. Place the diaphragm (fig. 1 A, 17) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
2. Place on the valve cover (fig. 1 A, 16) and screw it closed.
3. P lace the ventilating hose (fig. 1 A, 15) on the valve cover and on the nipple at the gun
body.
4. Slide the nozzle seal with the groove (slot) facing forwards into the nozzle
(Fig. 7).
5. Place the nozzle on to the gun body with the recess facing downwards.
Attention: Position of needle must be congruent with the nozzle aperture.
(Fig. 8)
6. Put the air cap (fig. 9, 3) onto the nozzle (4) and tighten it using the union nut (2).
7. Position the adjustment ring (figs. 10, 1) on the union nut so that the recesses on the
adjustment ring can snap into both horns on the air cap.
8. Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
9. Insert the suction tube with container seal in the gun body.
Pos. Designation
3 Nozzle seal (2 pcs.)
4 Nozzle
5 Air cap
6 Union nut
7 Spray jet adjustment ring
8 O-ring
11 Container seal
12 Suction tube
13 Container 1800 ml with cover
(only for WallPerfect spray attachment)
14 Feed hopper (3x)
15, 16, 17 Ventilating hose, valve cover, diaphragm
10
Spare Parts List (Fig. 1/ 1A)
WallPerfect I-Spray 1800
Order No.
2304 433
2328 908
2328 905
2328 903
2328 900
0417 308
2328 919
2328 922
2304 025
2304 028
2304 027