Preparation Of The Coating Material - WAGNER WallPerfect I-Spray 1800 Manual

WallPerfect I-Spray 1800
Before using the attachment, read these operating instructions and familiarise
yourself with the operating instructions for the basic unit. The safety instructions
for the basic unit apply to this WallPerfect spray attachment.
The WallPerfect I-Spray spray attachment has been especially developed for the
application of interior wall paints. A high feed rate and working speed are the main
features of this spray attachment.
1) Gun body
3) Nozzle seal
5) Air cap
7) Spray jet adjustment ring
9) Material quantity regulation
11) Container seal
13) Container
15) Ventilating hose
17) Diaphragm
Preparation of the workplace
Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Mask all the areas and objects that are not to be spray painted, or
remove them from the work area. No liability is assumed for damage
due to overspray.
Silicate paint corrodes glass and ceramic surfaces upon contact! All
such surfaces must therefore be completely covered.

Preparation of the Coating Material

Spray material that is at least at room temperature (e.g. diluted with warm
i
water) provides a better spray result.
Attention! Do not heat spray material above 40°C.
Interior wall paints can be sprayed undiluted or slightly diluted with the spray attachment
provided. Detailed information is available in the technical data sheet of the manufacturer
( Internet download).
1. Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Sprayed material
Interior wall paint (dispersions and latex paint)
2. If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 %
until the feed rate meets your requirements.
Description (Fig. 1 / 1A)
Thinning recommendation
2) Needle
4) Nozzle
6) Union nut
8) O-Ring
10) Trigger
12) Suction tube
14) Feed hopper
16) Valve cover
dilute by 0-10%
GB
7