Table of Contents
Advertisement
1.
Important safety notes
1.4
Safety regulations for proper use
17.
Remain with the machine until it has come to a standstill.
18.
Only have repairs carried out by a qualified specialist! Repair work may only be carried out by
persons who are qualified for the relevant repairs and who are familiar with the appropriate health
and safety requirements.
19.
Protect the machine from damp.
20.
Constantly check the machine for damages. Replace damaged parts only with original parts and
have these replaced by a specialist. The guarantee and warranty is voided if accessories and
replacement parts are use that are not designed for the machine.
21.
To avoid insufficient lighting, we recommend setting up a light source that provides a value of at
least 500 Lux at the tool's cutting edge.
22.
Do not remove the generated shavings with your hand. Use the appropriate tools (hand-held
sweeper, hook, brush).
23.
Never change tools and workpieces while machine is running.
24.
Tools and workpieces may never be changed when the machine is running.
25.
Workpieces must be secured by suitable fixtures e.g. prisms, machine vice etc..
26.
Chuck keys or similar tools may not be attached to the machine to ensure that they cannot be
caught by the spindle and thrown about.
27.
Never reach into the spindle opening of the main spindle with fingers (risk of crushing).
28.
The set-up mode may only be executed by qualified specialists.
29.
Return the operation selection switch to CNC operation after completion of set-up mode and
remove key.
30.
The magazine of the tool changer may only be loaded and unloaded via the spindle of the
machine.
8
Advertisement
Table of Contents
