WABECO CC-F1220 hs Operating Instructions Manual page 7

Cnc milling machine with tool changer
Table of Contents

Advertisement

1.
Important safety notes
1.4
Safety regulations for proper use
1.
Only specially trained persons may operate the machine. The guarantee and warranty are voided
if damages are caused by improper operation.
2.
We remind you that no liability will be accepted for damages caused by not observing these ope-
rating instructions.
3.
The operator of the machine is to ensure that at least one copy of the operating instructions is
stored in the immediate vicinity of the machine and available to the people who work with the
machine.
4.
The operator is to ensure that the safety and danger notifications on the machine are observed
and that the signs are kept in a legible state.
5.
Do not work without goggles.
6.
Wear close fitting clothing and, if you have long hair, wear a hair net. Do not wear loose fitting or
loose items (ties, shirt sleeves, jewellery etc.).
7.
Gloves may not be worn.
8.
In the event of an emission noise level as of 80 dB (A) at the workplace, ear defenders must be
worn.
9.
The machine may not operate without supervision.
10.
Secure your machine in such a way that it cannot be switched on by children. Persons who have
not been trained may not operate the machine.
11.
Before using the machine, make sure it is in good working condition. Pay special attention to any
damage to the grounded plug or the electrical connections. Never operate the machine with a
defective, crushed or exposed cable.
12.
Plug the grounded plug into a suitable socket for the machine. The cable for the machine may
only be connected to a safety socket or a connection box. Have the safety socket or connection
box checked by an electrical specialist before hand.
13.
The safety socket or connection box must be close enough to the machine that the power cable
is not under strain.
14.
When carrying out maintenance and cleaning work, the machine must be switched off and the
grounded plug pulled out.
15.
Set-up work is only to be carried out with the machine switched off.
16.
Do not reach into the operating machine.
7

Advertisement

Table of Contents
loading

Table of Contents