Table of Contents
Advertisement
4.
Specifications regarding the machine
4.6
Electrical equipment
The frequency-regulated main drive motor is delivered already installed
■
The under-voltage trigger is integrated in the electronics of the motor
■
The ON/OFF switch has to be switched on again also after an interruption of power
■
If the main propulsion motor is overloaded, it switches off automatically.
■
The main propulsion motor can only be reactivated after a short downtime.
■
For this purpose, first switch the machine off via the ON/OFF switch; wait 5 seconds and reactivate
5.
Achieving optimum results and avoiding incorrect usage
■
Use of suitable processing tools.
■
Adaptation of revolution setting and feed to the material and workpiece.
■
Clamp the tool in such a way that the clamping point is as close to the workpiece as possible.
■
Clamp the workpieces firmly and without vibrations.
■
The use of coolant and lubrication to increase the durability of the tool, improve surface quality and
accuracy.
■
Clamp processing tools and workpieces on a clean clamping surface.
■
Lubricate machine sufficiently.
■
Set the bearing clearance and guides correctly.
19
Advertisement
Table of Contents
