Huawei SmartACU2000D Series User Manual page 58

SmartACU2000D Smart Array Controller
User Manual (with No PID Module)
Figure 5-2 Tube and the diameter of cable holes at the bottom
(1) Nut
Step 1 Remove the locking cap and plug from the waterproof connector, and remove the waterproof
connector.
Step 2 Secure the tube fitting using the nut delivered with the tube.
Figure 5-3 Installing a tube fitting
Step 3 Route the cable through the tube conduit and then the fitting, and connect the cable.
Step 4 Secure the fitting to the conduit.
Step 5 Check that the cable is connected correctly and securely. Then take appropriate measures to
ensure that the tube conduit and fitting are secured reliably, and seal the cable hole using
supplied firestop putty.
Step 6 Clear foreign matter from the cabinet.
----End
Issue 01 (2020-02-14)
(2) Fitting
Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connections
(3) Conduit
51