Table of Contents
Advertisement
Figure 16. Replacing the UPIC cable into the system control unit
3) Push the white plastic lock (B) onto the plug housing as shown in the following figure.
Figure 17. Replacing the UPIC cable into the system control unit
4) Lightly pull on the UPIC cable from both attachment points to ensure it is locked into place.
Pull the cable connector; do not pull on the wire. The cables should be firmly attached to the
system.
b) Start the system. For instructions, see Starting a system (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/crustartsys.htm).
c) Continue with step "18" on page 21.
12. If you are using the AIX operating system, you must configure the adapter by completing the
following steps:
a) Install the AIX device drivers for the installed adapter.
For instructions, see Installing the AIX device driver software.
20 Power Systems: PCIe adapters for the 9080-M9S
Advertisement
Table of Contents
