Hardware; Boostxl-Edumkii Overview - Texas Instruments BoosterPack Educational Plug-in Module Mark II BOOSTXL-EDUMKII User Manual

Hardware

2 Hardware
Figure 2 is an overview of the BOOSTXL-EDUMKII hardware.
J4.39
Jumper select
RED_LED (RGB)
LCD Backlight
2-axis Joystick
w/ Pushbutton
}
HOR(X): J1.2
Use the analogRead(pin_number)
VER(Y): J3.26
function to read the raw analog
channels for each direction.
SEL: J1.5
Use digitalRead(pin_number)
read the state of the SEL button.
}
Microphone
Use analogRead(pin_number)
to read the raw analog values
from the microphone.
4
BOOSTXL-EDUMKII Educational BoosterPack™ Plug-in Module Mark II
Use the TMP006 & OPT3001 Library
readings from these sensors. TMP006 returns temperature,
while the OPT3001 reports back ambient light brightness.
TI OPT3001 TI TMP006
Light Sensor Temp Sensor
I2C_SCL: J1.9
GND
I2C_SDA: J1.10
INT_PIN: J1.8
1 21
}
Use the
Color
to display text, images
TFT LCD & basic shapes on the
to
screen.
40 pin
BoosterPack
J1.6
Connector
Figure 2. BOOSTXL-EDUMKII Overview
Copyright © 2015–2017, Texas Instruments Incorporated
GND
The alligator clip connectors allow you to turn almost anything
into an input. To use, hold the ground wire in one hand, then
use your free hand to touch the object that the other cable is
connected to. The state of the output will change when you
close the circuit!
J4.34
to get the sensor
I2C_SCL: J1.9
J4.34
I2C_SDA: J1.10
INT_PIN: J2.11
GND
PWR
SIG
40 20
LCD library
}
Buzzer
J4.40
SLAU599A – August 2015 – Revised March 2017
}
Use digitalRead(pin_number) function
to read the state of this input pin.
}
Servo Motor
Use Servo Library
the position of the servo motor
Connector
3-axis
accelerometer
}
X: J3.23
Use analogRead(pin_number)
Y: J3.24
to read the raw analog channels
Z: J3.25
}
User Push
Use digitalRead(pin_number)
to read the state of these input pins.
Buttons
J4.32
J4.33
RGB Multi-
Color LED
BLU: J4.37 }
Use analogWrite(pin_number, brightness)
GRN: J4.38
to output PWM at each RGB channel
RED: J4.39
Use tone(pin_number, frequency)
to output a tone at a specific frequency.
Try to import the "tone" library in Energia.
Submit Documentation Feedback
www.ti.com
to change