Commissioning Procedure; Commissioning Files - Siemens SINUMERIK 828D Manual

3 Commissioning
3.2.1

Commissioning procedure

•
Observe the Requirements.
•
Reset the SINUMERIK 828D to the factory settings using the drive wizard.
•
Load the commissioning files to achieve the following:
–
In the SINAMICS HLA, specific data of the internally used, purely fictitious
closed-loop hydraulic control are preassigned in order to avoid alarms.
–
All internal controllers of the SINAMICS HLA are deactivated.
3.2.2

Commissioning files

The commissioning files consist of an ACX or TEA file, both of which have the file
name "TTL_1024_SW_4_8".
You can use the files for linear and rotary axes. As soon as a TTL encoder that
supplies 1024 pulses per revolution is connected to both on-board interfaces, the
analog axis is immediately ready for operation.
If an SSI encoder, or sin/cos/EnDat encoder via SMC/SME, or a DRIVE-CLiQ
encoder is connected, you must adapt the encoder data in the commissioning
wizard.
Loading the commissioning files
Note Create a NC/PLC/DP archive before you load the commissioning files.
Note The procedure for loading the commissioning files is identical to that of a purely
electrical SINAMICS drive.
Load the commissioning files from a USB flashdrive:
•
Press the <MENU SELECT> key.
•
Open the "Setup" area.
Sollwertausgabe an analoge Antriebe
Entry ID: 109761423, V1.0, 10/2018
12