Advertisement
PARTS REQUIRED:
x8
ONCE MOUNTING HARDWARE IS INSTALLED, FOLLOW THE STEPS BELOW TO INSTALL
s.
POST SKIRT
BEGIN
When using post mounting hardware, there will be interference from protruding screws or nail
1
heads. Using a scrap piece of scrap wood (not included) and a Hammer, gently tap the wood
and Post Skirt against the mounting hardware to leave reference marks on the back side of the
Post Skirt (Fig. 1,2).
2
Use a hand tool to remove wood at marks (Fig. 5).
1
FINISH
3
Secure using four 2" (5,1 cm) À nish nails for each post skirt.
POST SKIRTS
7/8 x 3-3/8 x 11-7/8" (2,2 x 8,6 x 30,2 cm)
2
4
Post
Skirts x8
x32
3
5
Counter-sink all nail heads.
25
2" (5,1 cm)
Advertisement
