Advertisement
PARTS REQUIRED:
x1
Roof panels may cause serious injury until securely fastened.
¸
BEGIN
You must square the roof by attaching one panel À rst. You will use the panels' long
1
edge as a lever to bring your roof into square. Commonly known as "racking".
Attach the 48 x 96" panel with the stained side
2
down with a 3/4" measurement on the rafter
(Fig A) and the panel Á ush at the peak of
center brace (Fig. B).
Secure panel with two 2" nails in
the corners.
Fig. A
3
Move to the opposite end. Using the long
edge of the panel as a lever move the
panel side-to-side until the top of panel is
Á ush to the peak of center brace (Fig. C)
NOTE: Panels will overhang rafter
approximately 1-5/8" (4,1 cm) (Fig. D).
Secure panel with 2" nail in the center
brace (Fig. C) and bottom corner.
Approximately
Fig. D
ROOF PANELS
5/8 x 48 x 96"
(1,6 x 121,9 x 243,8 cm)
Two
Nails
3/4"
(1,9 cm)
Roof Panel
End Rafter
1-5/8"
(4,1 cm)
x4
23
2" (5,1 cm)
Flush
at peak
Fig. B
Top of panel Á ush to
peak of center brace
Fig. C
Advertisement
