Advertisement
PARTS REQUIRED:
x4
7/8 x 5-3/8 x 31-7/8" (2,2 x 13,7 x 81 cm)
1/4" (0,6 cm)
Drill Bit
BEGIN
1
Using pre-drilled holes in Gable Braces at bottom as a guide, drill 1/4" x 2" DEEP
pilot holes into the Front Header Assembly. DO NOT drill through Header.
Install using 5/16 x 3" Lag Bolt, 5/16" Lock Washer, and 5/16" Flat Washer.
2
Using pre-drilled holes in Gable Braces at top as a guide, drill 1/2" holes
through the Rafters. Install T-nut at back side of rafter and secure using
2-3/4" Hex Bolt, 3/8" Lock Washer, and 3/8" Flat washer as shown.
FINISH
3
Repeat Steps 1-2 for Back Header assembly
Flush
T-nut
GABLE END RAFTER BRACES
x4
5/16" Lock Washer
x4
x4
3/8" T-nut
3/8" Lock Washer
Flush
3/8" Flat Washer
3/8" Lock Washer
x4
x4
5/16" Flat Washer
x4
x4
3/8" Flat Washer
2-1/2" (6,4 cm)
Hex Bolt
21
5/16" x 3" Lag Bolt (7,6 cm)
3/8" x 2-1/2" Hex Bolt (6,4 cm)
5/16" Flat Washer
5/16" Lock Washer
3" (7,6 cm)
Lag Bolt
Advertisement
