Advertisement
PARTS REQUIRED:
x8
1-3/8 x 5-3/8 x 33" (3,5 x 13,7 x 83,8 cm)
BEGIN
1
Check all parts are square and level. Ensure diagonal measurements are equal.
2
Spread glue on portion of Corner Brace that will connect to Headers (Fig. A).
3
Attach Corner Braces to Headers with four 2-1/2" screws as shown.
Pre-drill Post Assembly 1/4" x 2" DEEP and attach with fasteners as
shown (Fig. B).
FINISH
4
Measure and mark side headers as shown.
Fig. A
Glue
1-3/8" x 5-3/8" x 33"
(3,5 x 13,7 x 83,8 cm)
HANDY HINT:
Plan ahead for Rafter install by marking
both Headers now.
CORNER BRACE ATTACHMENT
x4
x4
3/8" Lock Washer
3/8" Flat Washer
=
Mark
x4
3/8" x 4 1/2" Lag Bolt (11,4 cm)
x16
2-1/2" (6,4 cm)
2-1/2" (6,3 cm)
Fig. B
16
1/4" (0,6 cm)
Screw
Pre-drill for
Lag Bolt
Lock Washer
Flat Washer
4-1/2" Lag Bolt
Drill Bit
Advertisement
