Advertisement
PARTS REQUIRED:
x2
7/8 x 5-3/8 x 94-3/8" (2,2 x 13,7 x 239,7 cm)
x2
7/8 x 5-3/8 x 46-3/8" (2,2 x 13,7 x 117,8 cm)
BEGIN
1
Layout two sets of 94-3/8" and 46-3/8" Ridge Beams as shown.
Apply glue to underside and attach beams using two 1-5/8" screws
2
at 22" on center as shown.
Flip assembly and reinforce using two 1-5/8" screws at 22" on center.
NOTE: Offset screws on each side as shown
3
Measure and mark top of Ridge Beam as shown.
RIDGE BEAM
Ridge Beam
7/8 x 5-3/8 x 46-3/8"
(2,2 x 13,7 x 117,8 cm)
Ridge Beam
7/8 x 5-3/8 x 94-3/8"
(2,2 x 13,7 x 239,7 cm)
IMPORTANT:
Note dimension
17
x28
1-5/8" (4,1 cm)
IMPORTANT
Do not over drive screws
Glue
Mark
this face
Flush
Offset screws
Advertisement
