Advertisement
PARTS REQUIRED:
BEGIN
1
Place Ridge Beam Á ush to Center Braces (Fig. A), and tack in place with
temporary 2-1/2" screw from Center Brace into each end of Ridge Beam.
Drill 3/16" x 2" DEEP pilot holes into Ridge Beam through four holes at top of
2
Center Brace as guides.
Use 1/4" x 3" Lag bolts, Washers, and Lock Washers to attach Ridge Beam
3
using pilot holes.
Remove temporary screws.
FINISH
4
Repeat attachment process with Center Brace in back.
3" Lag Bolt
1/4" Flat Washer
1/4" Lock Washer
RIDGE BEAM INSTALLATION
1/4" Lock Washer
x8
Beam Flush
Fig. A
x8
x8
1/4" Flat Washer
Step 1
18
1/4" x 3" Lag Bolt (7,6 cm)
x2
2-1/2" (6,4 cm)
Step 1
2-1/2" (6,4 cm)
Screws
Advertisement
