Technical Specifications; Specifications - D&R WEBSTATION Manual

15 TECHNICAL SPECIFICATIONS

15.1 SPECIFICATIONS

INPUTS.
LINE
INSERTS.
EQUALIZER
USB
USB CONTROL SECTION. : 12 free assignable illuminated switches plus encoder, based on the HID protocol.
MIC ON
OUTPUTS
OVERALL
SOFTWARE
: Mic inputs
: XLR connector balanced impedance 2 kOhm.
: Pin 1 = ground.
: Pin 2 = hot (in phase).
: Pin 3 = cold (out of phase).
: +48 volt Phantom power
: bal, 2 kOhm, XLR. ,48 volt Phantom.
: Noise 128 dBr (A-weighted).
: Sensitivity- 70dB min, OdB Max.
: unbal, 10kOhm, Cinch.
: Gain range of 40dB.
: Stereo jack, -10dBv
: Tip =Input (connect to output of signal processor)
: Ring =Output (connect to input of signal processor)
: Ground =shield
: High: + / -12 dB at 12kHz shelving.
: Low: + / -12dB at 60 Hz shelving.
: 3x Stereo in and 3x stereo out (+ and incl VoIP)
: Fully compliant with USB 2.0 playback and record mode.
3x Stereo in and Main stereo, Voice Track or VoIP signal out.
HID Functions: Volume|Mute|Control
: Stereo jack, Tip is a change over contact between sleeve and ring.
NOT FOR 110/220 VOLT SWITCHING!!!!!!!
It can only switch 24V/50mA max!
: Left/Right + 0 dBu unbalanced on Cinch
: Headphone 32-600 Ohm, Jack.
: USB out can be Main program stereo signal/VoiceTrack/VoIP
: Frequency response: 10 - 60.000Hz.
: Distortion: < 0.01% max at 1 kHz.
: Start switch: isolated reed relay. (24volt/50mA)
: Metering On Screen
: A software protocol is available for programming of the USB HID protocol to match your software.
"We reserve the right to change or improve specifications when necessary"
W E B S T A T I O N M a n u a l P a g e 34