Module Settings; Power On Active; Auto Cue Reset; On Air Busses - D&R WEBSTATION Manual

12.4 Module Settings

In this chapter the module settings for the six modules within the console are discussed.
Each module has its own settings tab.
Apply a configuration section of the selected module to all other modules.
Apply entire configuration of the selected module to all other modules.

12.4.1 Power ON Active

The Webstation console contains ON-switches to activate a specific module.
If ON Active in the Power section is enabled the module will be active when powering the console. Using this function while a
power outage occurs prevents silence on air if no person is in the studio to (re-)activate the module.

12.4.2 Auto CUE Reset

When the CUE-switch of a module in the console is activated (also called PFL) the selected source (LINE or MIC/USB/VoIP) will be
routed to the CUE buss. To deactivate a module from the CUE buss you can press again the CUE-switch.
The Auto CUE Reset feature can reset the CUE buss (deactivate all modules from the CUE buss) automatically by Fader, ON and/
or Fader+ON. The function can be enabled for LINE and MIC/USB/VoIP separately.

12.4.3 On Air Busses

Two logical on-air busses are available which can be enabled for LINE and/or MIC/USB/VoIP for each module.
W E B S T A T I O N M a n u a l P a g e 25