Before Installation, Re-Installation Or Troubleshooting; Before Start-Up; During Operation; Misc - Linak DESKLINE DESK FRAME 2 User Manual

Before installation, re-installation, or troubleshooting:
• Stop the frame.
• Switch off the power supply and pull out the mains plug.
• Relieve the frame of any loads, which may be released during the work.

Before start-up:

• Make sure that the system has been installed as instructed in this User Manual
describing the motor system.
• Make sure that the voltage of the control box is correct before connecting the
system to the mains.
• System connection. The individual parts must be connected before connecting the
control box to the mains. See the User Manual for LINAK actuators, if necessary.

During operation

• If the control box makes unusual noise or smells, switch off the mains voltage
immediately.
• The maximum total load on the frame is 160 kg equally loaded, i.e. 80 kg on each
column. The 160 kg include the tabletop.
• Duty Cycle: 5 %, Max. 1 min./19 min. pause
• Take care that the cables are not damaged.
• Unplug the mains cable on mobile equipment before moving it.
• The products must only be used in an environment, that corresponds to their IP
protection.

Misc.

For further information, installation guidelines etc. for the motor system, please see
the relevant user manual: www.linak.com/deskline.
Updated manuals and declarations can always be found here:
www.linak.com/deskline.
Page 5 of 24