Control Locations - ABB FSCA-01 Manual

1 DATA IN 1
For Modbus register maps that include drive parameters, this
parameter specifies which parameter's value is read from when
the register corresponding to DATA IN 1 is read by the Modbus
master. For the content, see configuration parameter group B
table, parameter 1 (DATA OUT 1).
2...10 DATA IN 2 to DATA IN 10
See DATA IN 1 above.

Control locations

ABB Drives can receive control information from multiple sources
including digital inputs, analogue inputs, the drive control panel
and a communication module (eg, the FSCA-01 RS-485 Adapter
Module). ABB Drives allow you to separately determine the source
for each type of control information (Start, Stop, Direction,
Reference, Fault Reset, etc). To give the fieldbus master the most
complete control over the drive, the communication module must
be selected as source for this information. See the user
documentation of the drive for information on the selection
parameters.
21
Drive configuration