Table of Contents
Advertisement
Procedure
To screw on the panel front, proceed as follows:
1. Follow the installation instructions.
2. Drill four mounting holes at the prepared mounting cutout in accordance with the
3. Carefully drill the front drill-hole covers on the control unit from behind.
4. Place the assembled control unit and computer unit components into the recessed
5. Secure the control unit by inserting suitable screws through the holes and attaching nuts
SIMOTION P320-3 and Panel Fronts
Manual, 02/2012
specified installation dimensions.
CAUTION
Ensure that no metal cuttings enter the device. Cover the device with plastic sheeting, or
use a suction device when drilling.
Figure 5-8
Designated location for holes on the control unit
mounting cutout from the front so that the holes are aligned.
(torque 0.4 ... 0.5 Nm).
Note
The mounting depth increases by 21 mm when an optical drive is installed in the device.
Take the dimensions from the dimension drawings.
Installing/Mounting
5.5 Mounting the SIMOTION panel front
91
Advertisement
Table of Contents
