Table of Contents
Advertisement
Note
When using standard USB peripheral devices, please bear in mind that their EMC immunity
level is frequently designed for office applications only.
Such devices are suitable for commissioning and servicing purposes; however, industrial
components are recommended for normal operation in industrial environments.
NOTICE
IP65 degree of protection can no longer be guaranteed for an externally connected USB
device. You can only assume a degree of protection IP20. This also applies if the rubber
seal on the front-mounted USB interface is damaged or missing.
Rear-mounted interfaces
The SIMOTION panel fronts are usually supplied with an additional metal plate containing
three cutouts for cable routing. The two ribbon cables used to connect the remote module
(distributed configuration) as well as the USB cable, have to be connected to the interfaces
on the remote module (see SIMOTION P320-3 and Panel Fronts Commissioning and
Hardware Installation Manual). Removing this metal plate reveals the rear side of the panel
front as shown in the figure.
● The USB I/O cable K1 at X1 is for all signals responsible for the connection of control
● Display cable K2
● USB cable
Figure 3-13
SIMOTION P320-3 and Panel Fronts
Manual, 02/2012
units in addition to the display interface.
Interfaces on rear side of panel
Hardware description
3.5 SIMOTION panel fronts
59
Advertisement
Table of Contents
