Table of Contents
Advertisement
fcr0mst.book Page 1 Monday, July 13, 1998 9:36 AM
Chapter 3. Windows NT Installation
The EtherJet CardBus Adapter with 56K Modem supports
manual installation under Microsoft Windows NT 4.0. Plug and
Play installation and hot swapping of the EtherJet CardBus
Adapter with 56K Modem are not directly supported by Windows
NT.
When the EtherJet CardBus Adapter with 56K Modem is
installed, the other PC Card slot is available for use by another
PC Card.
Drivers Available
The following drivers for Windows NT can be found on the
Windows 95, 98, and NT Network Drivers Diskette:
• IBMC.SYS - NDIS3 driver
• IBMCN4.SYS - NDIS4 driver
• IBMMODEM.SYS - Modem enabler
Note: For the latest information on CardBus Adapter support in
Windows NT, review the README.TXT file on the
Windows 95, 98, and NT Network Drivers Diskette.
Installing under NT 4.0
1. Insert the EtherJet CardBus Adapter with 56K Modem into
the CardBus PC Card slot, as described in Chapter 1.
2. With the EtherJet CardBus Adapter with 56K Modem in the
PC Card slot, click Start, click Settings, and select the
Control Panel. The Control Panel opens.
3. Double-click the Network icon. The Network Settings window
opens.
4. Click the Adapters tab. The Network Adapters window
opens.
5. Click Add. The Select Network Adapter window opens.
6. Click Have Disk and insert the Windows 95, 98, and NT
Network Drivers Diskette.
© IBM Corporation, 1998
3-1
Advertisement
Table of Contents
Troubleshooting
