Plug And Play Installation (Versions 950B Osr2 And Later); Windows 95 And 98 Driver Parameters Reference - IBM 10/100 EtherJet CardBus Adapter with 56K Modem Installation And User Manual

fcr0mst.book Page 2 Monday, July 13, 1998 9:36 AM
Plug and Play Installation (Versions 950b
OSR2 and later)
1. If Windows displays the New Hardware Found window, insert
the Windows 95, 98, and NT Installation Diskette and follow
the instructions on the screen to complete the installation.
The networking and modem components will be installed
separately. If prompted to do so, reboot the system. IBM files
will be copied from the IBM diskette and both network and
modem functionality will be installed. If the New Hardware
Found window does NOT appear, proceed to step 2.
2. If the New Hardware Found window does NOT appear, you
may be running an earlier version of Windows 95 (950 or
950a). If that is the case, see the README.TXT file on the
Windows 95, 98, and NT Network Drivers Diskette.
Windows 95 and 98 Driver Parameters
Reference
IBMC.SYS is an NDIS3 driver. IBMCN4.SYS is an NDIS4 driver.
Both conform to the Microsoft Network Driver Interface Specifica-
tion (NDIS).
Required files for using IBMC.SYS with Windows 95 and 98
include:
NETIBMC.INF
IBMC.SYS
There are user-configurable parameters to the IBMC.SYS and
IBMCN4.SYS drivers which can be modified using the Network
Control Panel built into Windows 95 and 98. This applet queries
the user for parameter selections and sets the corresponding
parameters in the registry. User-configurable parameters follow:
Parameter
CableDetect
2-2 10/100 EtherJet CardBus Adapter with 56K Modem
Installation file for Windows 95 and 98
NDIS3 driver for Windows 95 and 98
Valid Values Reg. Value
Off
On
0
1